1976 Vintage Randall Commander 120 Aplifier

Posting ID : A1068540580
Date Posted : 2015-08-19
Category : Musical Instruments By Owner

Vintage 1976 Randall Commander 120 amplifier. Almost 40 years old this solid state amp has two 12" speakers and has an output of 120 watts (RMS) @ 4 ohms, 240 watts (PMP)@ 4 ohms

Solid State: Advanced Solid State - Built-in high safety factor - 4 high voltage heavy duty silicon when recording, Output impedance of pre-amp output is 20K ohms

Please note this this is the ORIGINAL Randall amp with the orange strip across the input area. This was changed about 1980.

Price is $350 FIRM. This is not only a practical amplifier for the studio and roadwork... it is a collectible.

Signal To Noise Ratio: 68 DB below rated output.

AC Line Voltage For Rated Output: 125VAC

Twin inputs with one master output. Channel 1 (two inputs) has has four pots (volume, bass, middle, treble) at +6mV with impedance of 1MEG ohm (High Gain)

Channel two (two inputs) has seven pots (volume, bass, middle, treble,pull treble boost switch, reverb, tremolo speed and intensity). 0.0 dB (regular) impedance 100k ohm.

200 Watt AC outlet at rear on amp.

Solid uni-cabnet construction

Heavy (23 ounce) embossed black vinyl with high gloss finish

Signal output jack in rear for powering another amplifier or FOH board or direct recording from amp into board.

Comes with circuit diagram booket as issued with Amp in 1976.

Pick up or local delivery within 10 miles of Beaver Valley Mall or Cranberry TWP.

Buyer pays actual shipping if out of the area.

Some Other Postings