Used PelPro / Dansons / Cci pellet Stove

Posting ID : B1007647610
Date Posted : 2012-02-18
Category : Appliances By Owner

You will see these at Aubuchon stores all the time.

Excellent opportunity for someone who is capable of doing some mechanical work.

The stove has been run for several years, we replaced it with another typo. This is a great unit for a shop/garage heating solution. The firebox, sheet metal, etc is in good shape. Also included about 3 feet of vent pipe, the exterior transtion wall feedthru, vent hood, and the feedthru bezel sheet metal. If you have priced this pipe, you know how expensive it is.

The elctronic controller is 100% operational. The room air circulation fan runs well.

You will need to perform the following to put this back into running condition. Once you have done this, you will have a good reliable pellet stove.

1-Purchase and install a replacement auger motor.The auger motor is NOT, repeat is NOT, installed into this stove. Auger motors are readily available at most Aubuchon stores, or can be ordered on line form numerous vendors. They are about $160.00 new.

2-the combustion fan is serviceable, but could use either a new set of bearings, or replacement. I beleive these are AO Smith motors.

3-The stove is located in a cellar, with 7 steps walk-up, with plenty of room. The buyer is repsonsible to remove the stove form the cellar. About 235 pounds I think.

$500.00 or best reasonable offer, terms are CASH only, CASH and Carry. Located in Templeton, MA

Some Other Postings